End stop for opening post form

Rubber insert for limiting length of the concrete post
Weight 530-620 g
Size: Front Width x Depth x Thickness
120x125x20 mm
130x125x20 mm
150x120x20 mm
125x110x20 mm
120x120x20 mm
125x125x20 mm
145x125x20 mm
Rubber thickness 20 mm
Shore A unit hardness 50-65
Strength 5-6.5 MPa
Color black

Rubber characteristics for the limiter:
The limiter is made of wear-resistant high quality molded rubber RTI.
Heat, frost, acid and alkali resistant.
Technical rubber, resistant to heat, frost, acids, alkalis.

Usage:
Insert the limiter for the opening post form into the inside of the post form by putting it on the grooves and set the required length.
In this way the length of the post on the slot side is adjusted.

Recommendations for the operation of the rubber stopper:
Favorable storage environment for rubber is a dry and ventilated room up to +25 ° C without access to sunlight.
To increase the service life of the product it is possible to exclude contact of oil products, acids, alkalis and other aggressive substances destroying the rubber.
For cleaning from concrete residues wash with water and for freshness of rubber treat with silicone.

* Please note that rubber stoppers/inserts are not universal and are only suitable for molds of a certain size.
Before ordering, please make sure that the dimensions of the post you have are the same as the dimensions of our rubber stop/insert.
If the pole form was purchased from us, it is necessary to determine its number in the catalog and look for the number of the rubber stop/insert under the same number.

* we manufacture rubber stops/inserts to individual dimensions.