FAQ

It is necessary to wash off the remains of cement deposits from the mold with a detergent after the mold is dry spray a gloss restorer on the surface and let it dry, after a few minutes the mold has a gloss will be restored if the scratches are deep - repeat the procedure until complete restoration

It is difficult to name the exact number of cycles, because it depends on many factors - the type of forms, size, relief, thickness, handling, lubrication, molding and storage. there is an approximate it is from 50 to 300 cycles

A frame for molds with a thickness of 1.8-3 mm is required, the material for its production can be metal, wood, osb, plywood, chipboard or a combination of these materials.

When pouring high-quality dense concrete using granite technology, marble from concrete can not be lubricated, but in this case, the gloss of the form and the quality of the surface will become worse; we recommend to lubricate lubricant-separator K-222, increase the terms of use of the form and the quality of the surface of the concrete products guaranteed!

When using molds, cement-sand often sticks in cracks and recesses on the front and other sides raid. Wash it off with a detergent (13% hydrochloric acid solution). Forms should be stored indoors, protected from ultraviolet rays, especially direct exposure, avoid sudden changes in winter below -1C.

Yes, all dry plasticizers need to be prepared, that is, diluted in a convenient amount of warm water and leave for at least 6 hours.

It is recommended to prepare the pigment before adding it to the solution, that is, dilute the dry pigment with warm water, get a creamy mass, leave for at least 6 hours (in this case, when adding pigment will work 100%, not 60% or 80%). Manufacturers of pigment recommendations for its addition to the solution is not offered, there is general information - 2-5% by weight of cement. Most add pigment to dry during kneading, without preparing it. Which method you choose - decide for yourself.